Eng 한글 繁體 简体

nRF5340 DK Development kit

Development kit for the nRF5340, a dual-core Bluetooth 5.4 SoC supporting Bluetooth Low Energy, Bluetooth mesh, NFC, Matter, Thread and Zigbee

The nRF5340 DK is the development kit for the nRF5340 System-on-Chip (SoC), containing everything needed to get started with development, on a single board.

The DK supports development with an extensive range of wireless protocols. It supports Bluetooth Low Energy with features such as high-throughput 2 Mbps, Advertising Extensions and Long Range. Mesh protocols like Bluetooth mesh, Thread and Zigbee can run concurrently with Bluetooth Low Energy, enabling smartphones to provision, commission, configure and control mesh nodes, which is a prerequisite for matter applications. It also supports NFC, ANT, 802.15.4 and 2.4 GHz proprietary protocols.

The DK is bundled with an NFC antenna that quickly enables testing of nRF5340’s NFC-A tag functionality. A SEGGER J-Link debugger is on the board, enabling full-blown programming and debugging, of both the nRF5340 SoC and external targets.

All analog and digital interfaces, and GPIOs are available via headers and edge connectors. The kit is Arduino Uno Rev3 hardware compatible, meaning it can be easily interfaced with external device shields.

Four buttons and four LEDs simplify input and output to and from the nRF5340 SoC, and are all user-programmable. An on-board external memory is connected to the 96 MHz QSPI peripheral in the nRF5340 SoC.

The nRF5340 DK is typically powered via USB, but can be powered by a wide range of sources, within the supply range of 1.7 to 5.0 V. In addition to USB, it can be powered with external source, but also includes a CR2032 battery holder and a Li-Po battery connector, for in-field testing. Current consumption can be measured by using the dedicated current measurement pins, for example by using Nordic's Power Profiler Kit II.

The nRF Connect SDK is the software development kit for the nRF5340 SoC, and it has board support for the nRF5340 DK. It supports software development of Bluetooth Low Energy, Thread and Zigbee applications. It integrates the Zephyr RTOS, protocol stacks, samples, hardware drivers and much more.

Hardware layout and schematics for the nRF5340 DK are available under Downloads.

Looking for the nRF5340 Preview Development Kit (PDK)? The nRF5340 DK replaces the nRF5340 PDK, but you can still find its product page here.

Download PDF  Download nRF5340 DK product brief [PDF]

Download PDF  Download nRF5340 DK product brief Simplified Chinese [PDF]

Ask us about this
Key features

Supports Bluetooth Low Energy, Bluetooth mesh, NFC, Matter, Thread and Zigbee

User-programmable LEDs(4) and buttons(4)

2.4 GHz and NFC antennas

SWF RF connector for direct RF measurements

On-board SEGGER J-Link debugger/programmer

Arduino Uno Rev3 form factor

Pins for measuring power consumption

1.7-5.0 V supply from USB, external, Li-Po battery or CR2032 coin cell battery

Documentation
Downloads

Peripheral UART

Demo firmware

Selected version
1.0.0

Changelog:

1.0.0

Built using nRF Connect SDK v2.2.0

Hardware files

for the nRF5340-DK

Selected version
2.0.0

Changelog:

2.0.0

  • Replaced the interface MCU for the on-board SEGGER J-link with an nRF5340 SoC.

1.0.0

  • Updated the nRF5340 SoC to IC revision 1 (production)

0.11.0